‘GO’ and ‘NO GO’ gauge is a type of
| ‘GO’ and ‘NO GO’ gauge is a type of
A. Limit gauge
B. Ring gauge
C. Slip gauge
D. Plug gauge
Please scroll down to see the correct answer and solution guide.
Right Answer is: A
SOLUTION
Explanation:
- Components manufactured using mass production methods are checked only to ensure that the sizes are within the prescribed limits.
- The most economical method of checking such components is by using limit gauges.
- These gauges are used in inspection because they provide a quick means of checking.
Go and No Go principle:
- The Go and No -Go principle of gauging is that the Go - end of the gauge must go into the feature of the component being checked and the No - Go end must not go into the same feature.
- The dimensions of the Go and No - Go ends of gauges are determined from the limits stated on the dimension of the component to be gauged.
- The dimension of the Go-end is equal to the minimum permissible dimension and that of the No -Go end is equal to the maximum permissible dimension.